So I'm working on a LUT and I keep getting massive shifts when I export it for my monitor. This is not the LUT I'm building but it clearly illustrates the issue.

Original shot

Original_1.1.1.jpg

Graded, a single point curve adjustment

Graded_1.2.1.jpg

Recorded LUT

Monitor Lut_1.3.1.jpg

I had similar problems when trying to build a display LUT for the Video Assist, small adjustments would become massive on the display. Is this a 33X vs. 17x cube issue? There is even a small difference when comparing the graded shot vs. the LUT applied to the same shot in Resolve but the difference is very slight and mostly negligible. Any advice would be appreciated.